Injection Molding of Mechanical Alloyed Ti-Fe-Zr Powder

GÜLSOY H. Ö., Gunay V., Baykara T., German R. M.

MATERIALS TRANSACTIONS, cilt.53, sa.6, ss.1100-1105, 2012 (SCI-Expanded) identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 53 Sayı: 6
  • Basım Tarihi: 2012
  • Doi Numarası: 10.2320/matertrans.m2012031
  • Dergi Adı: MATERIALS TRANSACTIONS
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED)
  • Sayfa Sayıları: ss.1100-1105
  • Anahtar Kelimeler: powder injection molding, sintering, mechanical alloying, titanium alloy, TITANIUM, MICROSTRUCTURE
  • Marmara Üniversitesi Adresli: Evet

Özet

This study focuses on the injection molding of mechanical alloyed Ti-Fe-Zr alloys. Injection molded samples were produced using mechanical alloying based on hydride-dehydride (HDH) titanium and pure iron and zirconium powders. Mechanical alloyed powders were mixed with a polymeric binder and hot injection molded to form standard tensile bars. The critical powder loading for injection molding was 50 vol% for feedstock. Molded bars were debound by solvent and then thermal steps, under ultra pure argon. Debound samples were sintered at 1300 C for 60 min in a high level vacuum (10(-5) mbar). After sintering, the performances of the sintered materials was characterized using tensile and hardness testing, optical microcopy (OM) and scanning electron microscopy (SEM). The strengths and weaknesses of the test conditions have been analyzed from the microstructure and mechanical properties. Theoretical density, ultimate tensile strength, and hardness of injection molded Ti powders increased with the additions of 5%Fe and 5%Zr. [doi:10.2320/matertrans.M2012031]