Optimization of Cutting Parameters, Condition and Geometry in Turning AISI 316L Stainless Steel Using the Grey-Based Taguchi Method


Basmaci G., Ay M.

ACTA PHYSICA POLONICA A, cilt.131, ss.354-358, 2017 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 131
  • Basım Tarihi: 2017
  • Doi Numarası: 10.12693/aphyspola.131.354
  • Dergi Adı: ACTA PHYSICA POLONICA A
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.354-358
  • Marmara Üniversitesi Adresli: Evet

Özet

In this study, experimental optimization of cutting forces, surface roughness and the hardness of material after turning of AISI 316L stainless steel, using conventional and wiper insert cutting tools under dry, CO 2 and MQL cutting conditions, is presented. The influences of feed rate, cutting depth, and cooling system on surface roughness, cutting force and material hardness were examined. In order to optimize the turning process, Grey relational analysis optimization method was used. The optimal machinability parameters of AISI 316L stainless steel with coated carbide insert were successfully determined.